Use the pen to write, click, double-click, or drag items. When pairing is successful a number is displayed on the LED indicator on the tablet. Press the red connecting button on the back of the tablet and the button on the USB adaptor at the same time for several seconds- up to 30 - 45 seconds. Press and hold the Power button for a few seconds until the LED is flashing. Connect the USB adaptor to a USB port on the computer. Remove USB adaptor from back of the tablet. Remove stylus pen from the back of the tablet. To use the Writing Tablet: The wireless tablet battery must be charged for a minimum of two hours. Note: Some of the speakers make a humming noise – the installers are working on a resolution.
#Hitachi starboard stylus pen Pc#
The volume control on your PC will slightly adjust the speakers. The volume on each speaker will need to be adjusted. As you look at the Califone logo on the front middle of the speaker, directly behind the logo are two knobs – the knob on the right adjusts the volume, the knob on the left adjusts the tone. To adjust the speakers: Volume controls are on the back of the speakers. If you are not sure which program will work, notify Debbie or Carol (or someone who might know).Įlkins Public Schools 3 Hitachi StarBoard Basic Instructions Use the program on your PC that operates the DVD player. If your computer has a DVD-ROM you can play DVDs. In PC mode you can display the Internet, PowerPoint, documents, or anything on your PC. Click and drag the tool bar to any location. To display your PC: Click the mouse PC button on the ‘floating’ tool bar. The number of your page is displayed in the upper right corner. Touch the left and right arrows on either side of the board to navigate “pages”. To begin writing on the board: Click new page for a new blank page. Navigate to “size”, select 16:9, and press Enter. To change projector settings: Press Menu button on remote, navigate to “picture”, and press Enter. Note: If the calibration circles are located on the border of the board that cannot be touched, the projector settings will need to be changed – press ESC to exit the calibration menu. Go to the next red blinking circle, repeat… Use the pen to touch the center of the Red blinking circle until it turns green. To calibrate StarBoard: Click the yellow StarBoard button On the popup menus click Settings > StarBoard> Calibrationįollow instructions on calibration screen.Įlkins Public Schools 2 Hitachi StarBoard Basic Instructions
The first step in using the StarBoard is to calibrate the board with the projector. We are hoping to find a fix for this problem. The computer monitor will lose connectivity until disconnected again. When using the StarBoard you must connect the black VGA cable to the Y-splitter on the back of the computer. The Planar (brand) flat monitor will not connect at the same time as the projector. Connections: Most of the computers are connected to both the monitor and the projector. The light will go off but the fan will continue to cool the bulb for a few minutes. Note: When turning off projector, press the power button twice. It will take about a minute for the bulb to beam. Power the projector on with remote- look for two blue lights under projector.
Elkins Public Schools 1 Hitachi StarBoard Basic Instructions
0 kommentar(er)
